Festo SLG-Z Serie Instrucciones De Utilizacion página 22

SLG-Z-...
Type
Tightening torque
– Cushioning support
– Fastening rail
– Intermediate position module
Fig. 14
Fasten the intermediate position module type SLG-Z-... as follows:
S
1. Push the sliding block into the groove (E)
of the fastening rail and screw the two
fastening screws through the intermedi-
ate position module into the sliding block.
It should then still be possible to shift the
intermediate position module type
SLG-Z-... .
2. Push the slide of the pressureless linear
drive (e.g. slide unit type SLG-...) by hand
into the intermediate position.
3. Align the intermediate position module in
the direction of the stop and place it in the
toothed profile of the fastening rail (stop
possible from left and from right). The
position of the stop to the mid-position
can then be adjusted by ± 0.75 mm.
The minimum permitted distance X
swivelling the stop lever and for the pneu-
matic connections X
here (see Fig. 17).
SLG-Z-...
Minimum distance
– for swivelling the
stop lever X
– for thescrew
connection X
Fig. 17
22
SLG-Z-8-...
2.9 Nm
1.2 Nm
0.76 Nm
1
must be observed
2
8-... 12-...
23 mm 23 mm
1
16 mm 16 mm
2
SLG-Z-12-...
2.9 Nm
1.2 Nm
0.76 Nm
(E)
Fig. 15
for
Fig. 16
18-...
x
2
31 mm
16 mm
Festo SLG-Z-... 0205NH English
SLG-Z-18-...
5.9 Nm
2.9 Nm
1.2 Nm
x
1
x
2