Festo SLG-Z Serie Instrucciones De Utilizacion página 26

SLG-Z-...
7. Check during the test run to see if the
following points need to be modified:
– The swivel-in time of the stop lever
(unrestricted the stop lever will strike
in the mid-position the slide of the
SLG-...).
– Position of the proximity switches
– Adjusting the stop lever.
The stop lever must be locked only on
the side which does not face the plate.
The following setting ranges are possible:
Type
Distance A
Distance A
Tightening torque
Fig. 25
Modifications may only be undertaken when the slide is at a stand.
8. Conclude the test run.
6 Operation
Using the intermediate position module with a rubber buffer.
Take into account the fact that the end position will change after long periods
S
of operation due to the continuous deformation of the rubber buffer.
With diagonal or vertical fitting of the module.
Use the cushioning variant with shock absorber type YSRG-... .
S
26
SLG-Z-8-...
2.5 mm
min
4.2 mm
max
2,9 Nm
A
Fig. 24
SLG-Z-12-... SLG-Z-18-...
3.7 mm
5.4 mm
5,9 Nm
Festo SLG-Z-... 0205NH English