Festo SLG-Z Serie Instrucciones De Utilizacion página 21

SLG-Z-...
Both end stops (A) of the SLG-... must
then be removed and fitted again at the
same height in the groove (B) of the
fastening rail.
2. Fasten the cushioning support with cen-
tring pins and the fastening screw sup-
plied to the slide of the linear drive (e.g.
type SLG-...).
Make sure that the alignment is correct. If
fitted correctly, the cushioning support
will be below the edge of the slide of the
SLG-... (see Fig. 11).
Fasten the fastening rail type SLG-S-... as
S
follows:
Place the fastening rail type SLG-S-... on
the profiled edge (C), position it with
dowel pins (D) and tighten with screws in
all the fastening holes. The supporting
surface must be level (see operating in-
structions for type SLG-...).
The tightening torques are shown in the
table below:
Festo SLG-Z-... 0205NH English
(B)
Fig. 10
Fig. 11
SLG-S-...
Fig. 12
Fig. 13
(A)
(C)
(D)
21