Commissioning; Battery Installation And Replacements; Initial Configuration - SOMFY Chronis io Manual Del Usuario

Chronis io

5. CoMMISSIoNING

Before commissioning the Chronis io, each motor must have been programmed by an installer
using an individual io control point or a setting tool and the end limits must have been adjusted.
This manual only describes commissioning using a Smoove io type individual io control point
To perform commissioning using a different io control point, refer to the corresponding manual.

The backlighting of the Chronis io switches off automatically after the device has been
inactive for a few seconds.
The Chronis io display switches off automatically after the device has been inactive for a few
minutes (time differs depending on mode).
5.1. Battery installation and replacements
Never use rechargeable batteries.
Replace the batteries when the ( ) symbol appears on the screen.
If there is no power supply for an extended period of time (> 2 min) (batteries out of charge or
removed), the date and time will have to be reset. The other settings are saved.
- Unclip the Chronis io from the wall mount (see section
Clipping on and unclipping the Chronis io from its wall
mount).
- Remove the used batteries from the compartment in the
back of the Chronis io.
- Insert 2 type AAA (LR03) batteries under the flap following
the polarity indicated.
- When the batteries are inserted, the screen lights up.
Batteries or accumulators have to be separated
from other types of waste and must be recycled
through your local treatment and recycling system.
5.2. Initial configuration
The factory configuration of the Chronis io is as follows:
• in standard end-product control mode: "
• with the standard radio frame repetition setting: "
• in control mode for non-self-powered motor: "
If the factory presettings are suitable for the installation, go on to the next section.
During initial configuration of the Chronis io, it is possible to set the parameters as a function of the
controlled end-product or end-products by selecting a control mode for the end-product, a radio frame
repetition setting and a control mode specific to self-powered motors.
Control modes for end-products:
4 control modes are available and you can change between these depending on the controlled
end-product:
• " ": To control all io-homecontrol
MODE STD : 1
garage doors, gates.
• " ": Recommended for the control of adjustable level lighting and heating.
MODE DIM : 2
• " ": Recommended for the control of exterior venetian blinds and roller shutters with
MODE TILT1 : 3
adjustable slats.
• " ": Recommended for the control of interior venetian blinds.
MODE TILT2 : 4
Radio frame repetition setting:
Depending on how the installation is configured, it is possible to increase the number of radio frame
repetitions (in the automatic and simulated presence modes). 5 settings are available: "
1 repetition, " " for 2 repetitions, "
:
RADIO 2
" : 5" for 5 repetitions.
RADIO
The higher the number of repetitions, the shorter the battery life is.
Control modes for self-powered motors:
If a self-powered motor is controlled by the Chronis io: choose the option "
4
".
MODE STD : 1
: ".
RADIO 1
SOLAR MOTOR : NO
end-products, for example roller shutters, windows,
®
: 3" for 3 repetitions, "
RADIO
Copyright © 2013 Somfy SAS. All rights reserved.
2 x LR03 AAA 1.5V
2 x LR03
AAA 1,5 V
".
RADIO
: 4" for 4 repetitions and
RADIO
SOLAR MOTOR : YES
.
" for
:
1
".