SOMFY Chronis io Manual Del Usuario página 7

Only perform the procedure below if at least one of these parameters has to be modified, to display
the version of the software or to reset the Chronis io to its factory configuration.
Otherwise go to the section Adding or deleting a Chronis io at an end-product.
While you are configuring the control mode for the end-product and the control mode specific
to self-powered motors, you can use the
end-product.
- Press the INSTAL button
Chronis io.
- The control mode for the end-product flashes.
- The parameters appear in the following order:
MODE ‹ › RADIO ‹ › SOLAR MOTOR ‹ › SOFT ‹ › RESET ‹ › EXIT ‹ › MODE ...
- To access another parameter, use the arrow keys ‹ or ›:
• To change the control mode for the end-product:
- Select " " and press OK: the current setting
MODE
flashes.
- Use ‹ or › to choose a setting and press OK.
- Choose "
:
SAVE
" by pressing ‹ or › if you do not want to save
NO
the setting and to return to the previous step) and
press OK.
• To change the radio frame repetition setting:
- Select " " and press OK: the current setting
RADIO
flashes.
- Use ‹ or › to choose a setting and press OK.
- Choose "
:
SAVE
" by pressing ‹ or › if you do not want to save
NO
the setting and to return to the previous step) and
press OK.
• To control a self-powered motor:
- Select "
SOLAR MOTOR
setting flashes.
- Choose "
SOLAR MOTOR : YES
press OK.
- Choose "
:
SAVE
" by pressing ‹ or › if you do not want to save
NO
the setting and to return to the previous step) and
press OK.
• To display the software version of the Chronis io:
- Select " ".
SOFT
• To reset the Chronis io to its factory configuration:
The end-products are still associated with the
Chronis io.
- Select " " and press OK.
RESET
- Choose "
RESET : YES
made (or "
RESET : NO
settings) and press OK.
- Repeat Chronis io commissioning in full.
• To terminate the procedure:
- Select " " and press OK: the Chronis io exits the
EXIT
initial configuration procedure.
Copyright © 2013 Somfy SAS. All rights reserved.
located on the back of the
" to save this setting (or "
YES
" to save this setting (or "
YES
" and press OK: the current
" by pressing ‹ or › and
" to save this setting (or "
YES
" to delete the settings you have
" by pressing ‹ or › to keep the
, , buttons to test the response of the
SAVE :
SAVE :
SAVE :
Chronis io
5