Operation; Manual Mode; Automatic Mode; Simulated Presence Mode - SOMFY Chronis io Manual Del Usuario

7. oPERATIoN

To change mode, move the mode selection cursor:

• Manual mode

• Automatic mode

• Simulated presence mode

7.1. Manual mode
The manual mode
• send occasional orders to the associated end-product or end-products.
• deactivate automatic order programming.
In manual mode
7.1.1.
button
- When the favourite position has been programmed and the end-product or end-products are
stopped, briefly press
positions (my).
- When the end-product or end-products are moving, you can press
7.1.2.
/ buttons
Configure the control mode corresponding to the type of end-product you want to control (see section
"Initial configuration"):
- In " ":
MODE STD : 1
• Brief press or long press: raise, switch on, open / lower, switch off, close.
- In " ":
MODE DIM : 2
• Brief press: fully switch on / switch off the lighting or the heating.
• Long press (> 0.5 s): increase / reduce the lighting or the heating.
- In " ":
MODE TILT1 : 3
• Brief press: tilt the slats of exterior venetian blinds or roller shutters with tiltable slats.
• Long press (> 0.5 s): Fully raise / lower exterior venetian blinds or roller shutters with adjustable
slats.
- In " ":
MODE TILT2 : 4
• Brief press: raise / lower the interior venetian blinds.
• Long press: tilt slats of interior venetian blinds.
7.2. Automatic mode
The automatic mode
• send occasional orders to the associated end-product or end-products.
• automatically control the associated end-product or end-products by means of automatic orders
programmed according to the days of the week.
- Program the automatic orders for each day of the week (see section "Programming the days of
the week").
Copyright © 2013 Somfy SAS. All rights reserved.
of the Chronis io is used to:
the current time is permanently displayed.
: the end-product or end-products move to the corresponding favourite
of the Chronis io is used to:
Chronis io
briefly again to stop them.
11