Extension Rail - Sauder Jaclyn Smith 416403 Manual Del Usuario

Step 3
Separate the EXTENSION SLIDES (P) from the
å
EXTENSION RAILS (O) as shown in the upper diagram.
Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (O) to the ENDS (A and B).
å
Use twelve GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into
this hole.
O
Open end
www.sauder.com/services
O
O
Finished edge
Push the release lever in and pull the SLIDE from the RAIL.
P
O
B
O
416403
3S
GOLD 5/16" FLAT HEAD SCREW
(12 used in this step)
O
O
A
Open end
Finished edge
Page 7