Before You Start; Tools; Exhaust; Electrical - Alliance Laundry Systems LES33A Instrucciones De Instalación

Tools

For most installations, the basic tools you will need are:
WRENCH
SCREWDRIVERS
DUCT TAPE

Exhaust

Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
NOTE: For more detailed information, refer to
Section on Dryer Exhaust Requirements.
4

Before You Start . . .

LEVEL
D074IE1F
TEFLON TAPE
D314IE0A

Electrical

• ELECTRIC DRYER
Dryer needs a 3 or 4 wire 120/240 Volt, 30 Amp, 60
Hertz, 1 Phase electrical supply.
• GAS DRYER
Dryer needs a 120 Volt, 15 Amp, 60 Hertz, polarized
3-slot effectively grounded receptacle.
NOTE: For more detailed information, refer to
Section on Electrical Requirements.

Gas

Dryer is equipped for Natural Gas with a 3/8" NPT gas
supply connection. For more detailed information,
refer to Section on Gas Requirements.

Location

Place the dryer on a solid floor with an adequate air
supply. For more detailed information, refer to Section
on Location Requirements.
504607