Electrolux EN3850DOX Manual De Instrucciones página 20

20 www.electrolux.com
Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
There is too much
frost and ice.
The temperature in
the appliance is too
high.
The temperature in
the refrigeration is
too high.
The temperature in
the freezer is too
high.
The appliance does
not operate.
Possible cause
The room temperature is
too high.
The Fast freezing function
is switched on.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Products are not wrapped
properly.
The door is not closed
correctly.
The Temperature regulator
may be set incorrectly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
Solution
Decrease the room temper-
ature.
Refer to "Fast freezing
function"
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Refer to "Closing the door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.