Shindaiwa HT231 Manual Del Propietario - Operador página 10

Maintenance (continued)
10 - hour maintenance
(more frequently in dusty conditions)
1. Remove the air filter element, and wash
the element in clean, neutral solvent
or warm soapy water. Rinse the ele-
ment thoroughly, and then squeeze dry
before reassembly.
CAUTION!
assembly is damaged or missing or
water!
10 - 15 hour maintenance
Remove and clean the spark plug.
Adjust the spark plug electrode gap to
0.024 - 0.028 inch (0.6 - 0.7 mm). If the
spark plug must be replaced, use only the
spark plug recommended on the Specifica-
tions section or an equivalent resistor type
spark plug of the correct heat range.
Every 20 and 100 hours
Gearcase lubrication
CAUTION!
Over-lubricating may cause the
gearcase to run slower than normal,
and may also cause leakage from
excess grease.
Do not remove the conrods from the
cutters. Conrod bearings can be lost
or damaged if disturbed.
Ever y 20 hours
Top off gearcase grease level by using a
lever-type grease gun to force 1–2 strokes
of high quality lithium-based grease
through the gearcase grease fitting.
Ever y 100 hours
(or before long-term storage)
Remove the gearcase cover, and use sol-
vent and a soft brush to remove all old
grease from the gearcase. To refill, hand-
pack the gearcase with approximately
40–50 grams of high quality lithium-based
grease (50–70% of capacity). DO NOT
OVERFILL!
10
CAUTION!
Before removing the spark plug, clean
the area around the plug to prevent
dirt and debris from getting into the
engine's internal parts. .
BOTTOM
VIEW
Hex screws
Gearcase lubrication
0.6–0.7 mm
(0.024–0.028 inch )
Remove the spark plug and adjust the
gap at the electrode
BOTTOM VIEW
Gearcase cover
DO NOTE REMOVE
CONRODS