Festo SLTE Serie Instrucciones De Utilizacion página 30

SLTE
Warning
Danger of injury from shearing, squeezing and abrading
Insufficient installation can cause the product to fall.
S Use the specified means of mounting, torques and fastening positions.
Note
S Do not modify the settings of screws and threaded pins if there is no request
to do this in these operating instructions.
For safety reasons the screws and threaded pins are fastened with a locking
device.
Note
The reference point cannot be ascertained accurately if reference travel is made
against a rubber buffer in the fixed stop.
S Make sure that there is no rubber buffer in the fixed stop to which reference
travel is made.
Reference travel against a fixed stop 6:
S
Use a suitable tool (e.g. pliers or screw­
driver) to remove the rubber buffer from
the fixed stop to which reference travel is
made. Dismantled rubber buffers should
not be used again. Two new rubber buffers
are included in delivery for cushioning the
end position again.
If the device is fitted in a vertical position,
reference travel against the upper fixed
stop is recommended due to the lack of
self-locking and the rubber buffer should
remain in the lower fixed stop.
30
Fig. 2
Festo SLTE 1505b English