Transcend EZEX Manual Del Usuario página 5

ASSEMBLING YOUR TRANSCEND EZEX
To completely assemble the Transcend EZEX Sleep Apnea Therapy System:
1. Attach the Universal Hose Adaptor to the 6-foot air supply tube then connect the universal hose adaptor to
the Transcend EZEX making sure it is fully seated into the CPAP.
2. Connect the interface (mask) to the patient (open) end of the 6-foot hose.
3. Plug the power supply barrel connector into the CPAP with the cord pointed up.
4. Connect the power supply to a power source.
2
4
1
Note: Your Transcend EZEX can also be powered by the optional
Transcend Mobile Power Adaptor or Transcend Battery.
Note: When power is supplied to the CPAP, the yellow light will
flash once followed by three quick flashes of the green LED
light. This sequence indicated power is being supplied to the
device and that it has successfully entered Standby mode.
Note: Do not use a power converter with your Transcend as it
may damage the device. Transcend automatically converts
voltage.
TRANSCEND EZEX QUICK GUIDE
3
• ENGLISH • PAGE 5