Starting Therapy - Transcend EZEX Manual Del Usuario

STARTING AND ENDING THERAPY

Starting Therapy

1. The Transcend EZEX control
panel consists of a Power
button (bottom), Ramp button
(top), and two LED lights.
(Refer to image)
2. Ensure that the device is
connected to a power source
and is in Standby mode.
3. Put on your mask and make
sure that proper fit is achieved.
4. Press the lower, gray Power button (
begin as the blower delivers your prescribed therapy pressure.
Using the Ramp Function
Ramp settings will be programmed by your healthcare provider as prescribed.
1. Initiate ramp by pressing the Ramp (top) button after the Power button has been pressed.
Note: The Ramp button on the Transcend EZEX will not work unless your healthcare provider has
preset the ramp function.
2. Pressure from the device will be lowered to a preset starting pressure and will gradually increase
over a preset time interval until the device reaches your prescribed starting therapy pressure.
3. To accelerate the ramp time, hold down the Ramp button. The device will quickly increase
pressure until reaching your prescribed therapy pressure.
Ending Therapy
To end therapy, press the Power button to return the device to Standby mode.
Green LED
) to turn on Transcend EZEX and enter Therapy mode. Air flow will
TRANSCEND EZEX QUICK GUIDE
Power Button
• ENGLISH • PAGE 7
Ramp
Button
Yellow LED