Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
YOUR SAFETY IS IMPORTANT TO YOU AND TO OTHERS,
SO PLEASE READ THESE INSTRUCTIONS BEFORE YOU
OPERATE THIS HEATER.
GENERAL HAZARD WARNING:
FAILURE TO COMPLY WITH THE PRECAUTIONS AND
INSTRUCTIONS PROVIDED WITH THIS HEATER, CAN
RESULT IN DEATH, SERIOUS BODILY INJURY AND
PROPERTY LOSS OR DAMAGE FROM HAZARDS OF
FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON
MONOXIDE POISONING, AND/OR ELECTRICAL SHOCK.
ONLY PERSONS WHO CAN UNDERSTAND AND FOL-
LOW THE INSTRUCTIONS SHOULD USE OR SERVICE
THIS HEATER.
IF YOU NEED ASSISTANCE OR HEATER INFORMATION
SUCH AS AN INSTRUCTIONS MANUAL, LABELS, ETC.
CONTACT THE MANUFACTURER.
CONTENTS
Section 1 INTRODUCTION.........................................................2
Section 2 PLANNING.................................................................3
Section 3 INSTALLATION & ASSEMBLY.....................................6
Section 4 ENGINEERING SPECIFICATIONS ..............................12
Section 5 VENTING/DUCTING................................................ 13
Section 6 GAS PIPING..............................................................16
Section 7 WIRING....................................................................17
Section 8 OPERATION MAINTENANCE....................................18
Section 8 TROUBLESHOOTING................................................20
Section 9 REPLACEMENT PARTS..............................................23
WARRANTY INFORMATION....................................................24
SECTION 1:Introduction
Heatstar ER2STG models are low-cost, field assembled infrared
heaters that are easy to install and require only minimal
maintenance. They are designed to provide years of economical
operation and trouble-free service.
Checking Shipment
Check the shipment against the Bill of Lading for shortages.
Also, check for external damage to cartons. Note any
shortages, and/or external damage to cartons on the Bill of
Lading in the presence of the delivery trucker. The delivery
trucker should acknowledge any shortages or damage by
initializing this "noted" Bill of Lading. Immediately report any
claims for damaged material, or shortages that were not
evident at the time of shipment, to the carrier and your Enerco
Group, Inc Factory Representative.
Enerco | Heatstar ER2STG Tube Series Heater
WARNING:
FIRE, BURN, INHALATION, AND EXPLOSION HAZARD.
KEEP SOLID COMBUSTIBLES, SUCH AS BUILDING MATERI-
ALS, PAPER OR CARDBOARD, A SAFE DISTANCE AWAY
FROM THE HEATER AS RECOMMENDED BY THE INSTRUC-
TIONS. NEVER USE THE HEATER IN SPACES WHICH DO OR
MAY CONTAIN VOLATILE OR AIRBORNE COMBUSTIBLES,
OR PRODUCTS SUCH AS GASOLINE, SOLVENTS, PAINT
THINNER, DUST PARTICLES OR UNKNOWN CHEMICALS.
WARNING:
THIS PRODUCT CAN EXPOSE YOU TO CHEMICALS INCLUDING
LEAD AND LEAD COMPOUNDS, WHICH ARE KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS
OR OTHER REPRODUCTIVE HARM. FOR MORE INFORMATION
VISIT WWW.P65WARNINGS.CA.GOV
WARNING:
Fuels used in liquefied propange gas appliances, and the products
of combustion of such fuel, can expose you to chemicals including
benzene, which is known to the state of California to cause can-
cer and cause birth defects or other reproductive harm, for more
information go to www.P65Warnings.ca.gov
Installer Responsibility
All heaters and associated gas piping should be installed in
accordance with applicable specifications and this installation
made only by firms (or individuals) well qualified in this type of
work. Consult local building inspectors, Fire Marshals or your
local Enerco Group, Inc Factory Representative for guidance.
Heatstar ER2STG heaters are installed on the basis of
information given in a layout drawing, which together with the
cited codes and regulations, comprise the basic information
needed to complete the installation. The installer must
furnish all needed material that is not furnished as standard
equipment, and it is his responsibility to see that such materials,
as well as the installation methods he uses result in a job that is
workmanlike and in compliance with all applicable codes.
Enerco Group, Inc Factory Representatives have had training
and experience in the application of this equipment and can
be called on for suggestions about installation which can save
material and money.
2
Operating Instructions and Owner's Manual
Publicidad
Tabla de contenido
