Wall Mount; Technical Specifications - Kärcher BC 1/7 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
 Remove the battery pack and insert it in
the device.
Note: The charged battery pack can re-
main on the charger till it is to be used.
There is no risk of over-charging.
Note: In order to avoid unnecessary energy
consumption, however, the charger should
be unplugged as soon as the battery pack
is fully charged.

Wall mount

146 mm
 Remove the two rubber feet with a
screwdriver.
 Check the wall for load-bearing capaci-
ty prior to installation. Weight of the de-
vice including the battery pack, see
"Technical data".
– The mains plug must always remain
freely accessible.
Troubleshooting
– Red LED glows:
The battery pack is too hot or too cold.
The charging process starts when the
battery pack has reached the correct
charging temperature.
– Red LED blinks:
Battery pack has not been placed cor-
rectly on the battery holder.
Battery pack is defective.
8
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.

Technical specifications

BC 1/7
Voltage range of re-
chargeable battery
Charging current
Battery type
Mains voltage
Frequency
Max. input
Typical operating
weight
Dimensions (l x b x h)
Battery pack
Typical op-
kg
erating
weight
– 3
EN
Warranty
V
14,4...36
A
6,5
--
Li-Ion
V
220...240
Hz
50-60
W
290
kg
1,1
mm
183 x 176 x
92
BP 250/
BP 500/
18
18
0,5
0,8
BP 750/
36
1,8

Publicidad

Tabla de contenido
loading

Tabla de contenido