Control Panel; Connecting The Power Supply; Before First Use - Silvercrest SWKD 2400 B2 Instrucciones De Uso

Control panel

The control panel
Display:
Arrow buttons ▼ ▲: increase/decrease target temperature
button:
button:
Fig. 2

Connecting the power supply

CAUTION – PROPERTY DAMAGE!
► Before connecting the appliance, compare the connection data of the
appliance (voltage and frequency) on the rating plate with that of your
electrical supply. This data must correspond in order to prevent damage to
the appliance.
♦ Unwind the power cable from the cable retainer
♦ Guide the power cable through the gap in the back of the base
♦ Insert the plug into a mains power socket. Insert the plug into a mains power
socket. If the jug
and the current temperature of any water contained in the jug is then shown
on the display
seconds.
Before fi rst use
Before starting to use the appliance, ensure that the appliance, the plug and the
cable are in a fault-free condition and that all packaging materials are removed
from the appliance.
Before preparing water for consumption for the fi rst time, you need to clean the
jug . Proceed as follows:
♦ Open the lid
■ 24
│ GB│IE
is made up of the following components:
temperature display
switch appliance on/off , start/cancel heating process
switch keep-warm functionon/off
is placed on the base
. The appliance is now in standby mode for around 30
by pressing the release button
.
, the button lights up
.
SWKD 2400 B2
.