Channel Setting; Operating The Radio Set - Silvercrest KH 2131 Instrucciones De Uso

Channel setting

GB
MT

Operating the Radio Set

52
NOTICE
► Two signal sources can be connected to the radio transmission set. The
signal to be transmitted can be selected with the switch ROOM 1
ROOM 2 on the back of the transmitter.
12
► To switch over, for example, the signal source AV1 for a TV connected to
the transmitter, place the switch ROOM 1
Connection example Transmitter).
► To switch over, for example, the signal source AV2 for a TV connected to
the receiver, place the switch ROOM 2
Connection example Transmitter and Connection example Receiver).
You can operate up to four radio transmission sets at one location.
When using multiple radio transmission sets, they must be set to diff erent channels.
The transmitter and receiver of each radio transmission set must be set to the
same channel for a successful transfer.
Select a channel (A/B/C/D) with the channel selector switch
transmitter.
Select the same channel with the channel selector switch
Switch the transmitter on by pressing the On/Off switch
Switch the signal source on, for example, a DVD player, and, if necessary,
start playback.
Switch the receiver on by pressing the On/Off switch
Switch the target device on, for example, a TV, and activate the A/V input
to which you have connected the receiver.
The radio transmission should now function.
NOTICE
► The device transmits the audio/video signals in the 2.4 GHz frequency
range. Take note that, in the 2.4 GHz frequency range, there is no general
protection against listening in or viewing.
Handling and operation
at the position 1 (see Fig.
11
at the position 2 (see Fig.
12
resp.
11
on the
5
on the receiver.
17
.
2
.
14
KH 2131