Nozzle / Accessories
• Figure I - A crevice tool is built into the nozzle
and can be extended as shown in figure H by
pulling the extension piece until it locks into
position.
• Figure J - A brush accessory is built into the
nozzle and can be flipped upwards for use.
• Figure K - The nozzle can be rotated for better
access in tight spots. To rotate the nozzle, press
the button shown in figure K and rotate the nozzle
to the left or right until it clicks into place.
Replacing the filters
The filters should be replaced every 6 to 9 months and whenever worn or damaged.
Replacement filters are available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
Maintenance
Bowls and filters can be washed thoroughly; however, use only mild soap and a damp
cloth to clean the main part of the vacuum.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
Troubleshooting
If the product does not work, check the following:
• The charge indicator light is flashing when unit is connected to charger.
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached.
• The charger is plugged into a working electrical outlet.
• The switch is in the "OFF" position when charging.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at
1-800-544-6986.
Accessories
Recommended accessories for use with your product are available from your local dealer
or authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
• Filter accessory number VF110.
I
J
K
7