Napa 6-794 Manual De Instrucciones página 2

FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY.
THIS INSTRUCTION MANUAL CONTAINS
IMPORTANT SAFETY INFORMATION.
READ THIS INSTRUCTION
MANUAL CAREFULLY
AND UNDERSTAND ALL
INFORMATION BEFORE
OPERATING THIS TOOL.
• Always operate, inspect and
maintain this tool in accordance
with American National Standards
Institute Safety Code of Portable Air
Tools (ANSI B186.1) and any
other applicable safety codes
and regulations.
• For safety, top performance and
maximum durability of
parts, operate this tool
at 90 psig/6.2 bar max
air pressure with 1⁄2"
diameter air supply hose.
• Always wear impact-resistant eye
and face protection when
operating or performing
maintenance on this
tool. Always wear
hearing protection
when using this tool.
• High sound levels can cause
permanent hearing loss.
Use hearing protection
as recommended by
your employer or
OSHA regulation.
• Keep the tool in efficient
operating condition.
• Operators and maintenance
personnel must be physically able to
handle the bulk, weight and power
of this tool.
• Air under pressure can cause severe
injury. Never direct air at
yourself or others.
Always turn off the air
supply, drain hose of air
pressure and detach tool
from air supply before in-
stalling, removing or adjusting any
accessory on this tool, or before
performing any maintenance on this
tool. Failure to do so could result in
injury. Whip hoses can cause serious
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.
6-794
injury. Always check for
damaged, frayed or
loose hoses and fittings,
and replace
immediately. Do not
use quick detach
couplings at tool. See instructions
for correct set-up.
• Air powered tools can vibrate in
use. Vibration, repetitive
motions or
uncomfortable positions
over extended periods
of time may be harmful
to your hands and arms.
Discontinue use of tool if
discomfort, tingling feeling or pain
occurs. Seek medical advice before
resuming use.
• Place the tool on the work before
starting the tool. Do not point or
indulge in any horseplay with
this tool.
• Slipping, tripping and/or falling
while operating air tools
can be a major cause of
serious injury or death.
Be aware of excess hose
left on the walking or
work surface.
• Keep body working stance balanced
and firm. Do not overreach when
operating the tool.
• Anticipate and be alert for sudden
changes in motion during start up
and operation of any power tool.
• Do not carry tool by
the hose. Protect the
hose from sharp objects
and heat.
• Tool shaft may continue to rotate
briefly after throttle is released.
Avoid direct contact with accessories
during and after use. Gloves will
reduce the risk of cuts or burns.
2
• Keep away from rotating end of
tool. Do not wear jewelry
or loose clothing.
Secure long hair.
Scalping can occur if
hair is not kept away
from tool and
accessories. Choking can occur if
neckwear is not kept away from
tool and accessories.
• Do not lubricate tools with
flammable or volatile liquids such
as kerosene, diesel or jet fuel.
• Impact wrenches are not torque
control devices. Fasteners with
specific torque requirements must
be checked with suitable torque
measuring devices after installation
with an impact wrench.
• Use only impact wrench sockets and
accessories on this tool. Do not use
hand sockets and accessories.
• Do not force tool beyond its
rated capacity.
• Do not remove any labels. Replace
any damaged labels.
• Use accessories recommended by
NAPA Professional Air Tools.
Rev. 06/06/03