Care And Cleaning; What To Do If Repairs Are Needed - Sammic HM-1900 Manual De Instrucciones

The buzzer volume.
Operation
Turn the TIMER KNOB to left until display shows "0".
Touch START key first and also touch POWER
SELECTION key 190W until display changes.
Turn the TIMER KNOB to change setting.
When you don't change setting, skip steps 3.
Touch START key.

CARE AND CLEANING

ALWAYS KEEP THE OVEN CLEAN.
1. Cleaning the glass viewing window, the inner door panel and oven front face.
For best performance and to maintain the high degree of safety the inner door
panel and oven front face should be free of food or grease build-up.
Wipe these parts with a mild detergent, rinse and wipe dry.
Never use abrasive powders or pads.
2. Cleaning the oven interior
After use be sure to clean up spilled liquids, spattered oil and food debris as
quickly as possible. If the oven is used when dirty, efficiency drops and the dirt
gets stuck on the oven surface and may cause bad odours. Clean the interior
with a cloth soaked in luke-warm water with a mild detergent dissolved in it,
then rinse the soap off with a damp cloth.
In particular, the bottom of the oven interior tends to get stained from spices and
food. Since this may cause odour and abnormal vibration, be sure to keep this
area clean.
CAUTION: Do not wipe plastic and painted sections of the oven with bleach,
thinners or other cleaning agents, as this may cause these parts to dissolve
or change shape.
3. The stirrer shield (inside oven top) can be gently wiped in place or removed
for washing at the sink. The shield is a mica, supported at front, side and rear.
Carefully remove the shield secured at the front tabs, pull forward to remove.
Wash only in warm (not hot) detergent water, rinse and wipe dry. Avoid hitting
or bending the metal stirrer blades, as this could change the heating pattern in
the oven.
To replace the shield, position it on the rails on sides and rear of the cooking
14 ENGLISH
Display window
The display indicates number of current set-
ting.
1 - quiet
2 - medium
3 - loud
"0" appears in the display.
Buzzer volume.
chamber and secure it between the front metal tabs.
4. Clean the removable air filter regularly. (at least once a week)
Do not operate oven without air filter in position.

WHAT TO DO IF REPAIRS ARE NEEDED

1. If any of the following appear, check for a problem.
"U-50" flashes in the display window.
When using Programme Selection Keys the key must be touched within 1
minute of closing the door.
After inserting the power plug into the wall outlet, open and close the door and
then touch the key.
- Open and close the door, and then touch the key before 1 minute passes.
· The purpose of this function is to prevent operation when there is no food in
the oven.
"U-10" appears in the display window.
The oven operates empty without food in it.
- Touch CLEAR key, place food in oven and start again.
2. This is normal operation:
Cooling fan operates for a while after heating has completed or heating has
been stopped by opening door or touch CLEAR key during operating.
- Cooling fan operating continues for five minutes to keep the electronic com-
ponents cool.
3. This is abnormal operation:
Get in contact with your nearest Service center or retailer.
This oven is provided with self-diagnostic function.
- When the window display indicates the error code "E" (example: E-21), it