Restoring The Original Configuration; Technical Data; Technical Specifications - SOMFY ilmo 50 S WT Guia De Instalacion

ilmo 50 S WT

8.2 Restoring the original configuration

8.2.1 Using the control point connected to the
Caution: Follow each of the 4 steps in the proce-
dure carefully to correctly restore the original
configuration.
Place the roller shutter in the mid-height
1)
position.
Caution: Repeat the next step 3 times in
2)
succession
Press the Up button until the roller shutter
-
moves. Release the button immediately.
Caution: Repeat the next step twice in
3)
succession
Press the Down button until the roller shutter
-
moves. Release the button immediately.
Press the Down button again until the roller
4)
shutter makes 2 successive movements in the
same direction.
►
8.2.2 Using the wired electronic motor setting
Press the Up and Down buttons on the setting
-
tool at the same time until the roller shutter
makes an initial up and down movement
followed by a second one.
►

9. Technical specifications

Power supply
Operating temperature
Index protection rating
42
54273X03_ilmo50Swt.indb 42
roller shutter
The motor has been restored with the
original configuration. Repeat the commis-
sioning process.
tool
The motor has been restored with the
original configuration. Repeat the commis-
sioning process.
1
3
7 s
230V/50 Hz ~
- 20°C to + 70°C
IP 44
Copyright © 2008 - 2009 Somfy SAS. All rights reserved.
Installation guide
2
x 3
4
x 2
5/02/09 17:29:26