Installation; Tube Preparation - SOMFY SOLUS P&P Guia De Instalacion

EN

2. INSTALLATION

Instructions whichmust be followed by the drive and home automation professional
installing the SOLUS P&P drive.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each drive.
Never connect 2 control points to a single motor.
2. 1. INSTALLATION
damaging the roller shutter and/or the Somfy product.
For information about the compatibility of the drive with the roller shutter and accessories,
contact the roller shutter manufacturer or Somfy.
2. 1. 1. Preparing the drive
Check that the inner diameter of the tube is 47 mm or
greater.
1)
the roller tube:
b and the drive wheel c on the drive.
Measure the length (L1) between the inner edge of the
2)
motorisation head and the rim of the drive wheel.

2. 1. 2. Tube preparation

Install a SOLUS P&P motor in a roller tube with a minimum thickness of 0.5 mm and a
smooth inner surface: with no welding, crimping, folding, etc. inside the tube.
1)
the motorised product.
Deburr the roller tube and remove the swarf.
2)
For smooth roller tubes, cut a notch with the following
3)
measurements:
d = 4 mm (0.16 in)
•
e = 28 mm (1.1 in)
•
14
Images not contractually binding
a on the drive.
1)
Ø = 47 mm
a
2)
L1 = ...
1)
3)
Copyright © 2017 Somfy SAS. All rights reserved.
Ø > 47 mm
b c
L1
2)
d
e