Commissioning; Tips And Recommendations For Installation - SOMFY SOLUS P&P Guia De Instalacion

EN

2. 3. COMMISSIONING

tube, check that when the roller shutter is in the lower
end limit position, the rigid link is correctly positioned
(as per F). If necessary, adjust the number of slats
used to improve the position of the rigid link when the
roller shutter is in the lower end limit position.
to select those suited to the roller shutter used.
Use at least 2 rigid links to attach the roller shutter to the roller tube.
Switch the power back on.
1)
Press the "Up" button at the control point:
-
If the roller shutter rises, the wiring is correct and
•
•
Switch off the power.
2)
Reverse the brown wire and the black wire connected
-
to the control point.
Switch the power back on.
3)
Press the "Up" button to check the direction of rotation.
-

2. 4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2. 4. 1. Questions on the SOLUS P&P?
Problems
The roller shutter is
turning in the wrong
direction.
The roller shutter is
not operational.
The roller shutter
stops too soon.
The roller shutter
does not stop when
it reaches the lower
end limit position.
16
Images not contractually binding
Possible causes
The wiring is incorrect.
The wiring is incorrect.
The drive is hot.
The control point is not
compatible.
The roller shutter is
encountering friction when
it moves: friction along
the runners and case,
interference between the
roller tube and the drive, etc.
The drive has been installed
in a new roller shutter.
The mountings used are not
correct.
F
F
1
ON
2
OFF
3
ON
Solutions
Check the wiring and modify it if
necessary.
Check the wiring and modify it if
necessary.
Check for compatibility and replace the
control point if necessary.
Check the roller shutter installation and
correct any friction.
If the problem continues, restore the
Restore the drive to its original
Check that the roller shutter is mounted
to the roller tube using rigid links.
Copyright © 2017 Somfy SAS. All rights reserved.
OK
2
OK