Kohler K-98741-K1 Guía De Instalación Y Cuidado página 10

Escutcheon
Ribs
Groove
Nozzle Membrane
7. Install the Trim
Attach the Sprayhead
Using a 5/32" hex wrench, secure the sprayhead to the waterway with the two hex screws. Do not
overtighten.
Check that the sprayhead sits squarely within the escutcheon and tilts freely up and down.
Place the nozzle membrane over the sprayhead, aligning the long edge of the membrane with the
ribs.
NOTE: For optimum performance, make sure the nozzle membrane is applied evenly.
Applying pressure evenly, press the membrane seal into the sprayhead groove.
Repeat for the remaining sprayheads.
Attach the Sprayface
Tilt the sprayhead to expose the ribs.
Position the grooves of the sprayface over the hinge ribs, then rotate the loose end of the sprayface
up as illustrated.
Press the sprayface into place to cover the sprayhead.
Tilt the sprayhead assembly to expose the setscrew holes.
IMPORTANT! To avoid product damage, the setscrews must not protrude beyond the sprayface.
Using a 5/64" hex wrench, turn the setscrews counterclockwise until they are flush with the edge of
the sprayface.
Repeat for the remaining sprayfaces.
1235394-2-A
Waterway
Sprayhead
Hex Screws
10
Ribs
Sprayface
Setscrews
Kohler Co.