Installing The Software In Windows 3.1 Or Nt 3.5X - Epson LQ-300+ Manual Del Usario

Note:
If your CD-ROM drive has a drive letter other than E, substitute the appropriate
letter. The installation program starts. The subsequent procedure is menu-
driven, i.e., you can select the relevant options from a list simply by clicking
with the mouse. The remainder of the installation is automatic and you do not
need to enter any more information.
4.
Select the desired options and follow the on-screen instructions.
5.
After the printer software has been successfully installed, click on the button
identified by a door icon to exit the installation program.
Note:
If the New Hardware Found screen or any other wizard appears when you
turn on your computer, click Cancel and follow the steps above.
Installation time varies depending on your computer.
For information on opening and using the software, see chapter 3 "Using the Printer
Software" in the online User's Guide. After you install the printer driver on Windows
Me, 95, 98, 2000 or NT 4.0, you can install the EPSON Status Monitor 3 utility program.
See "About the EPSON Status Monitor 3 Utility" in chapter 3 of the online User's Guide
for information on installing and using the Status Monitor.

Installing the software in Windows 3.1 or NT 3.5x

Follow the steps below to install the printer software in Windows 3.1 or NT 3.5x
systems.
Note:
Installing the printer software on Windows NT 3.5x may require network
administration privileges. Ask your administrator for more information.
1. Make sure Windows 3.1 or NT 3.5x is running and the Program Manager
window is open.
2.
Insert the EPSON printer software CD-ROM shipped with your printer in the CD-
ROM drive.
Note:
If your system does not have a CD-ROM drive, you can make a floppy disk
version from which to install the printer software.
3. From the File menu, choose Run. The Run dialog box appears. In the Command
Line box, type E:\START and click OK.
18