FujiFilm SonoSite PowerPark Guia Del Usuario página 7

2 Disconnect the power cord from the wall outlet, and pull the PowerPark dock away from the wall.
The circuit breaker is now accessible.
3 Press the circuit breaker to the desired position: ON ( | ) or OFF (O).
To reset the stand module circuit breakers
One or both of the circuit breakers on the stand module trip if there is a power event (for example, a power
surge) and may need to be reset.
1 Locate the two breakers on the end of the power module under the stand base, near the stand height
adjustment pedal.
2 Press in on each circuit breaker switch until it closes. See the following figure.
On a correctly closed circuit breaker, the switch is pressed in.
On a tripped circuit breaker, the switch is popped up and exposes a white plastic area.
Note If you cannot press down the switch and if no white area is exposed, the
circuit breaker is closed.
Troubleshooting Troubleshooting
Breaker closed Breaker tripped
5 5