Cleaning And Disinfecting - FujiFilm SonoSite PowerPark Guia Del Usuario

Cleaning and disinfecting

Caution Use only approved cleaners or disinfectants on surfaces.
The exterior surfaces of the PowerPark stand module and the PowerPark dock should be kept clean.
Whenever you clean the system stand, be sure to also clean the attached PowerPark stand module. Clean
and disinfect the PowerPark dock periodically, or whenever it appears dirty or comes into contact with
biomatter or bodily fluids. Refer to the cleaners and disinfection tool available at
www.sonosite.com/support/cleaners-disinfectants
To clean the PowerPark stand module and dock
1 Disconnect the PowerPark components from any power source:
For the PowerPark stand module, turn off the ultrasound system and any accessory equipment.
Disconnect the stand from the PowerPark dock or unplug the power cord.
For the PowerPark dock, disconnect it from its AC power.
6
WARNINGS
To avoid electrical shock, before cleaning, always disconnect the PowerPark
dock from AC power.
To avoid injury, always use protective eyewear and gloves when performing
cleaning and disinfecting procedures.
To avoid infection:
Ensure that the solution expiration date has not passed.
The level of disinfection required for a product is dictated by the type of
bodily fluids or tissue it comes into contact with during use. Ensure that the
solution strength and duration of contact are appropriate for the equipment.
For information, see the disinfectant label instructions and the
recommendations of the Association for Professionals in Infection Control and
Epidemiology (APIC) and FDA.
Caution Do not allow cleaning solution or disinfectant to come into contact with
the PowerPark electrical connectors.
for a list of approved cleaners and disinfectants
.
Cleaning and disinfecting