Ryobi RPW36X120HI5 Traducción De Las Instrucciones Originales página 6

cleaner.
6. Press the power switch to turn on the
product.
NOTE: The product uses a brushless
motor and a soft start. The water will come
out a little later after gripping the trigger.
To stop the product:
■
Switch off the power switch.
NOTE: The fan will keep running to cool
down the product 1 minute after the unit
has been shut off.
USE OF POTABLE WATER SUPPLY
■
The product can use potable water. Use
Ryobi suction hose kit and water bags for
the connection.
■
When connecting the product to the water
supply, follow the regulations from the local
water supplier.
CAUTION
If you connect the product to a potable
water supply, you must install a backflow
prevention device to the water supply
system. The installation should be installed
by professional service personnel and
should be accepted by the local water
supplier.
■
Make sure there is water in the hose and
pump before turning on the product.
WARNING
If there is no water coming out from the
nozzle, stop the product immediately using
the power switch. Working without water
may cause serious damage to the pump.
USE OF WATER BAG
The product can use a water bag as water
supply source.
To use a water bag:
1. Close the outlet valve by rotating the
outlet cap clockwise of the water bag.
2. Remove the inlet
anticlockwise and fill the water bag.
Replace the inlet cap.
3. Place the water bag at least 0.5 m above
the high pressure cleaner.
4. Connect the water bag outlet to the water
inlet of high pressure cleaner using a
4 | English
5.
6.
USE OF 5-IN-1 NOZZLE
There are fi ve spray pattern settings located
on the 5-in-1 nozzle. To select a spray
pattern, rotate the spray selector to the
desired setting.
cap by rotating
garden hose.
Open the outlet valve by rotating the
outlet cap anticlockwise of the water bag.
Start the product according the steps on
"To start the product" section.
WARNING
The product must be primed before turning
it on. There should be water at the pump
and high-pressure hose before turning on
the product.
It usually takes time to release the air in
hose and pump. Do not run the product
until there is a steady fl ow coming out from
nozzle.
WARNING
Remove the inlet cap when the product is
running, otherwise the water coming out will
be much slower. Running the product with
insuffi cient water supply may damage it.
WARNING
Do not splash water to high pressure
cleaner. It may damage the electric parts
and the battery pack.
Nozzle Application
Spot cleaning of high, hard-to-
reach areas
■
Removing caked-on mud
from
farm, or lawn equipment
■
Cleaning
0°
stubborn
concrete
■
Cleaning overhead areas
■
Removing rust from steel
and oxidation from aluminum
heavy construction,
tar, glue, or
stains from