Peavey TRIPLE XXX Guia De Funcionamiento página 8

NOTE: FOR UK ONLY
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and
yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored
green, or colored green and yellow. (2) The wire that is colored blue must be connected to the
terminal that is marked with the letter N or the color black. (3) The wire that is colored brown must
be connected to the terminal that is marked with the letter L or the color red.
FOOTSWITCH
31
(30) CABLE CONNECTOR
This 7-pin DIN connector is provided for connecting the footswitch to the amplifier REMOTE
SWITCH (20) via the cable included in the carton. Connections at the switch and the amplifier
should be made before the amp is powered up.
(31) ULTRA / CRUNCH SELECTOR
This switch selects between the Ultra and Crunch channels on the amplifier. The adjacent
LED will illuminate when the Ultra channel is selected. When the LED is dark, the Crunch
channel is selected. The CLEAN SELECTOR (32) must be in the BYPASS mode to activate
either the Ultra or Crunch channel.
(32) CLEAN SELECTOR
This switch selects the Clean channel and will activate regardless of the position of the
ULTRA / CRUNCH SELECTOR (31). The adjacent LED will illuminate when the Clean
channel is selected. This switch must be in the BYPASS position, indicated by a dark LED, in
order to utilize the ULTRA / CRUNCH SELECTOR (31).
(33) EFFECTS SELECTOR
This switch activates the amplifier's effects loop (16 – 19). The adjacent LED will illuminate
when the effects loop is active.
30
32
8
33