Airwell YDZC Manual De Usuario página 11

The air conditioner turns to FAN ONLY
mode from COOL or HEAT (for cooling and
heating models only) mode.
When the indoor temperature reaches the set
temperature setting, the compressor will stop
automatically, and the air conditioner turns to
FAN only mode. The compressor will start again
when the indoor temperature rises on COOL
mode or falls on HEAT mode to the set point.
Droplets of water may form on the surface of
the indoor unit when cooling occurs in relatively
high humidity (de ned as higher than 80%).
Adjust the horizontal louver to the maximum air
outlet position and select HIGH fan speed.
Energy Saving Tips
DO NOT set the unit to excessive temperature levels.
•
While cooling, close the curtains to avoid direct sunlight.
•
Doors and windows should be kept closed to keep cool or warm air in the room.
•
DO NOT place objects near the air inlet and outlet of the unit. This will reduce the efficiency of the unit.
•
Set a timer and use the built-in SLEEP/ECONOMY mode if applicable.
•
If you don't plan to use the unit for a long time, remove the batteries from the remote control.
•
Clean the air filter every two weeks. A dirty filter can reduce cooling or heating efficiency.
•
Adjust louvers properly and avoid direct airflow.
•
Closing curtains during heating also
helps keep the heat in
Heating mode (For cooling and heating
models only)
The air conditioner draws in heat from the
outdoor unit and releases it via the indoor unit
during heating. When the outdoor temperature
falls, heat drawn in by the air conditioner
decreases accordingly. At the same time, heat
loading of the air conditioner increases due to
larger di erence between indoor and outdoor
temperature. If a comfortable temperature
cannot be achieved with the air conditioner
alone, it is recommended that you use a
supplementary heating device.
Lightning or a car wireless telephone operating
nearby may cause the unit to malfunction.
Disconnect the unit from its power source and
then re-connect the unit with the power source
again. Push the ON/OFF button on the remote
controller to restart operations.
Doors and windows should be kept
closed
 Page 9 