Fitting The Handlebar - BH FITNESS H9180O5 Instrucciones De Montaje Y Utilización

4.- FITTING THE HANDLEBAR

Position the handlebar (21) in the
handlebar stem (37), Fig 5, tighten the
knob (62) and
handlebar stem (37) into the hole on
the main body (A), Fig 5. Position it
correctly and then tighten knob (Y) by
turning it clockwise.
ADJUSTING THE HANDLEBAR
HORIZONTALLY
Position the handlebar (21) at a
comfortable distance
exercise, now
securely, Fig 5.
Stay within the references.
ADJUSTING THE HANDLEBAR
VERTICALLY
Position the handlebar (21) at a
comfortable distance
exercise, now
securely, Fig 5.
Stay within the references without
going beyond the "MIN INSERT"
mark.
EXERTION SETTINGS
To provide an even level of exertion
during exercise,
equipped with a tensioning control (31),
located on the stem of the main body
(A), Fig 6. This provides various exertion
settings when turned clockwise.
To increase pedal resistance turn the
tensioning control (31) clockwise (+)
until the exertion level best suits your
exercise requirements.
To reduce pedal resistance turn the
tensioning control (31) anticlockwise (-).
then insert
for doing
tighten knob
for doing
tighten knob
this appliance
During exercise the flywheel will get
hot due to the braking effect, so when
you have finished exercising it is
advisable to set the tensioning control
the
(31) to minimum in order to help stop
the brake shoe from hardening.
Important: This tensioning control
(31) is equipped with an emergency
braking system which, when applied
with force (as shown by the arrow in
Fig 6), produces a much sharper
braking effect.
(55)
LEVELLING.
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (13) up or down, as
shown in Figure 6.
(Y)
MOVEMENT & STORAGE
The unit is equipped with wheels (15)
Fig 6, to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Figure 7. Store your unit in a dry
is
place,
changes in temperature.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
THE MANUFACTURER RESERVES
THE
SPECIFICATIONS OF ITS PRODUCTS
WITHOUT PRIOR NOTICE.
11
preferably not
RIGHT TO MODIFY
subject to
THE