Sincro HB 2 Manual Para El Uso Y Mantenimiento página 16

ENGLISH
1. SAFETY RECOMMENDATIONS
2. CONFORMITY DECLARATION
3. INTRODUCTION
3.1 Control of ID plate
3.2 Position of plate with electrical specifications, serial number and production lot
4. OPERATING PRINCIPLE AND CHARACTERISTICS OF THE VOLTAGE REGULATOR SYSTEM
4.1 AVR board
5. GENERAL MECHANICAL AND ELECTRICAL SPECIFICATIONS FOR COUPLING WITH MOTOR
6. INSTALLATION
6.1 Lifting
6.2 Mounting on motor
6.2.1 Assembly format IM B35
6.2.2 Dismantling format IM B35
6.2.3 Assembly format SAE
6.2.4 Dismantling format SAE
6.3 Earthing
6.4 Preliminary Controls
6.4.1 Control of electrical insulation
6.4.2 Direction of rotation
6.4.3 Control of voltage and frequency
6.4.4 AVR board settings
6.4.5 Wiring diagrams for different circuits
6.4.6 Initial start-up
7. AFTERSALES ASSISTANCE AND MAINTENANCE
7.1 Control of windings and electrical insulation
7.2 Control of bearings
7.3 Troubleshooting
7.4 Removal and replacement of components and component assemblies
7.4.1 Extracting and inserting the shaft
7.4.2 Changing bearing
7.4.3 Changing rotating diodes
7.4.4 Changing exciter rotor
7.4.5 Replacing components and component assemblies
8. CLEANING AND LUBRICATION
9. DISMANTLING AND DISPOSAL
10. SPARE PARTS AND AFTERSALES
10.1 Aftersales procedure and contact addresses
11. WARRANTY
16 - HB - Maggio 2004 - Rev. 00