Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10. LIGHT BULBS
This insert must use shielded halogen lamps (120 V, 50 W, MR16 or PAR16 with GU10 base), included.
In order to prevent the risk of personal injury, do not install a
lamp identified for use only in enclosed fixtures.
1. Install the lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
In order to prevent the risk of personal injury, the halogen
lamps must be cooled down before removing them.
To remove lamps, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
11. INSTALL BAFFLE FILTERS
Remove protective plastic film covering the baffle filters before installing them.
It is recommended to install side filters first and finish with center one(s).
A vertical arrow with the word AIR can be found on the filters border. Make sure
to install the baffle filters with the arrow pointing towards the inside of the hood.
See figure beside.
1.
Insert upper end of baffle filter into the hood.
2.
Raise lower end of baffle filter to position inside of hood and push to insert
the rear clip inside its slot in baffle back side.
3.
While pushing the baffle filter, slide it under the inner retaining piece.
Make sure the baffle filters are positioned as shown beside in order to allow the
grease to reach the grease rail easily.
WARNING
!
WARNING
!
CAUTION
1
HO0090
- 8 -
2
HO0026
1
2
3
HO0027
Publicidad
Tabla de contenido
