Light Bulbs - Best WPD28I Manual De Instalación

10. LIGHT BULBS

This hood requires shielded halogen lamps (120 V, 50 W, MR16 or PAR16 with GU10 base), included.
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk
of personal injury, only install shielded halogen lamps. Also, never install a cool beam, a dichroic
lamp, a lamp not suitable for use in recessed luminaires or identified for use in enclosed fixtures.
1. Install the lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
To remove lamps, gently push upwards and turn counterclockwise to
disengage bulb leads from their grooves.
NOTE: To ease removal of the bulbs, use a rubber dishwashing glove or
use suction cup tool available from Best. Contact Best Customer
Service at 1-800-558-1711 to order suction cup tool, part
no. 99526707.
11. INSTALL BAFFLE FILTERS
Remove protective plastic film covering the baffle filters before installing them.
It is recommended to install side filters first and finish with center one(s).
A vertical arrow with the word AIR can be found on the filters border. Make sure
to install the baffle filters with the arrow pointing towards the inside of the hood.
See figure at right.
1. Insert upper end of baffle filter into the hood.
2. Raise lower end of baffle filter to position inside of hood and push to insert
the rear clip inside its slot in baffle back side.
3. While pushing the baffle filter, slide it under the inner retaining piece.
Make sure the baffle filters are positioned as shown at right in order to allow the
grease to reach the grease rail easily.
WARNING
!
CAUTION
- 8 -
1
HO0090
HO0026
1
2
3
HO0027
2