Light Bulbs - Best PIK33D Instrucciones De Instalación

Ocultar thumbs Ver también para PIK33D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

14. INSTALL THE INTERIOR BLOWER (P8D BLOWER MODEL ONLY) (
Make sure the impellers are correctly installed, the insert will not work properly if reversed.
Both impellers are different in the dual blower, one rotates
clockwise and the other counterclockwise. Each wheel and
motor have an arrow and a number on them, you have to
match them correctly (see drawing at right).
Pass the blower cable through the plastic clamp (A) in the wiring box. Completely tighten the
plastic clamp. See figure at right.
Connect blower cable into wiring box using provided waterproof wire connectors.
W
ATERPROOF WIRE CONNECTORS INSTRUCTIONS
1 Strip wires 3/8".
2. Align frayed strands or conductors.
3. Do not pre-twist. Place stripped wires together with ends even, but lead smaller
stranded wires slightly ahead of larger solid or stranded wire.
4. Twist connector onto wires pushing firmly until hand-tight. DO NOT over torque.
5. When inserting wires into connectors, some sealant may leak out. Wipe off excess
sealant in and around conductors. DO NOT REUSE.
Connect wires as follow: ORANGE to ORANGE (B), WHITE to 2 other WHITE wires (C)
from step 10, and GREEN under ground screw (D). DO NOT FORGET TO CONNECT
THE GROUND. Reinstall the wiring box cover.

15. LIGHT BULBS

This insert requires shielded halogen lamps (120 V, 50 W, MR16 or PAR16 with GU10 base), included.
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk of
personal injury, only install shielded halogen lamps. Also, never install a cool beam, a dichroic lamp, a
lamp not suitable for use in recessed luminaires or identified for use in enclosed fixtures.
1. Install the lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
To remove lamps, gently push upwards and turn counterclockwise to disengage bulb
leads from their grooves.
NOTE: To ease removal of the bulbs, use a rubber dishwashing glove or use suction
cup tool available from Best. Contact Best Customer Service at 1-800-558-1711
to order suction cup tool, part no. 99526707.
CAUTION
HD0023
:
WARNING
!
- 10 -
CONT
FRONT
1
Not completely
VO0084
B
D
HE0033
1
HO0090
'
)
D
2
A
Completely
tightened
tightened
A
C
2

Publicidad

Tabla de contenido
loading

Tabla de contenido