Wiring - Harbor Breeze CC52WW5C Manual De Instrucciones

INITIAL INSTALLATION
5.
Remove motor screws (M) and lock washers (L) from
underside of motor and save for blade arm (F)
attachment later on. [If there are plastic motor blocks
installed with the motor screws (M) and lock washers
(L), discard the plastic motor blocks.] (Fig. 5)
6. Slide the slot in the bar at the top of the motor
assembly (D) onto the "J" hook on the mounting
bracket (A) to support the fan during wiring. (Fig. 6)
Important: Do not use the end of the bar on the
motor assembly (D) with the small round hole to
hang the motor assembly (D) on the mounting
bracket (A).

WIRING

WARNING: To reduce the risk of fire, electrical
shock, or personal injury, wire connectors provided
with this fan are designed to accept only one 12
gauge house wire and two lead wires from the fan. If
your house wire is larger than 12 gauge or there is
more than one house wire to connect to the two fan
lead wires, consult an electrician for the proper size
wire connectors to use.
CAUTION: Be sure outlet box is properly
grounded and that a ground (green or bare) wire is
present.
WARNING: If house wires are different colors
than referred to in the following steps, stop
immediately. A professional electrician is
recommended to determine wiring.
5
D
6
"J" Hook
Bar
D
7
Motor
L
M
A