Final Installation - Harbor Breeze CC52WW5C Manual De Instrucciones

WIRING
2.
Wrap electrical tape around each individual wire
connector (CC) down to the wire as shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
Hardware Used
E3 Wire Connector
CC
IMPORTANT: Using a full range dimmer switch to
3.
control fan speed will cause a loud humming noise
from fan. To reduce the risk of fire or electrical
shock, do NOT use a full range dimmer switch to
control fan speed. (Fig. 3)

FINAL INSTALLATION

1.
Remove motor assembly (D) from "J" hook and lift
motor assembly (D) to mounting bracket (A). Align
holes and secure motor assembly (D) with
mounting bracket flat washers (J) and mounting
bracket nuts (K) that were previously removed
(Step 3, page 6). (Fig. 1)
2
CC
x4
3
1
9
CC
CC
3
2
1
Dimmer
Speed
Switch
Switch
For illustrative purposes only--not
intended to cover all types of controls
J
K
D
A