Hanging Instructions; Wiring Instructions - Harbor Breeze LP8007LABN Manual Del Usuario

HANGING INSTRUCTIONS

To avoid possible electrical shock, be sure
WARNING:
electricity is turned off at the main fuse box before hanging. (Fig. 7)
NOTE: If you are not sure if the outlet box is grounded, contact
a licensed electrician for advice, as it must be grounded for
safe operation.
The fan must be hung with at least 7' of clearance
WARNING:
from the floor to blades (Fig. 8)
1. Securely attach the hanger bracket (C) to the outlet box
using the outlet box screws and washers supplied with the
outlet box. (Fig. 9)
The outlet box must be securely anchored.
WARNING:
Hanger bracket must seat firmly against outlet box. If the outlet
box is recessed, remove wallboard until bracket contacts box.
If bracket and/or outlet box are not securely attached, the fan
could wobble or fall.
2. Carefully lift the fan and seat the downrod/hanger ball
assembly (D) on the hanger bracket (C) that was just attached
to the outlet box. Be sure the groove in the ball is lined up with
tab on the hanger bracket. (Fig. 10)
Failure to seat tab in groove could cause
WARNING:
damage to electrical wires and possible shock or fire hazard.
To avoid possible shock, do not pinch wires
WARNING:
between the hanger ball assembly and the hanger bracket.

WIRING INSTRUCTIONS

To avoid possible electrical shock, be sure
WARNING:
electricity is turned off at the main fuse box before hanging. (Fig. 11)
NOTE: If you are not sure if the outlet box is grounded, contact
a licensed electrician for advice, as it must be grounded for
safe operation.
C
7
Fig. 7
OFF OFF
OFF OFF
OFF OFF
OFF OFF
Fig. 8
Ceiling
No
less than
7 ft
Floor
Fig. 9
Outlet
Box
Screw (2)
(Supplied
with
Outlet Box)
Tab
Fig. 10
Outlet
Box
C
D
Fig. 11
OFF OFF
OFF OFF
OFF OFF
OFF OFF