Wiring; Final Installation - Harbor Breeze LARALYN LRN32 Manual Del Usuario

CLOSEMOUNT STYLE FAN MOUNTING
4. Align mounting holes on canopy (B) with
holes on motor housing assembly (H) and
fasten using three previously removed
screws. Securely tighten screws.
5. Hang the fan on the hook on the mounting
bracket (A) using one of the non-slotted holes
in the canopy (B).

WIRING

1. Connect the BLACK and BLUE wires from
the fan to the house BLACK wire. Connect
the WHITE wire from fan to the house
WHITE wire. Connect all GROUNDED
(GREEN) wires together from fan to the
house GREEN/GROUND wire.
NOTE: BLACK wire is hot power for
fan. BLUE wire is hot power for light kit.
WHITE wire is common for fan and light kit.
GREEN wire is ground wire. If house wires
are different colors than referred to above,
stop immediately. Consult a licensed
electrician to determine proper wiring.
4
H
JJ
5
Hook
A
1
Supply circuit
Grounded/Green
White
White
Black
Black
Grounded/
Blue
Green
10
WIRING
2. Tape the wire connectors (AA) and wires
together. The wires should be spread apart with
the grounded conductor and the equipment-
B grounding conductor on one side of the outlet
box and the ungrounded conductor on the other
side of the outlet box. Be sure no bare wire or
wire strands are visible after making connection.
Place green and white connections on opposite
side of box from the black and blue connections.
The splices should be turned upward and
pushed carefully up into the outlet box.
Hardware Used
AA Wire Connector

FINAL INSTALLATION

If you chose "Downrod-Style Mounting,"
continue to Step 1. Proceed to Steps 2-3 if
you chose "Closemount-Style Mounting."
1. Directly align the locking slots of the canopy
(B) with the preassembled screws in the
mounting bracket (A). Push up to engage the
slots, then turn clockwise to lock in place.
Immediately tighten the two screws firmly.
Install the non-slotted screws previously
removed (Step 3, page 6) to canopy (B) and
B
tighten securely.
Proceed to Step 4.
2. Remove the fan from the hook on the
mounting bracket (A). Align the locking slots
of the canopy (B) with the two screws in the
outlet box
mounting bracket (A). Push up to engage the
GREEN/
slots, then turn clockwise to lock in place.
GROUNDED
Immediately tighten two screws firmly.
speed
switch
2
AA
x 4
Outlet box
1
B
2 Outlet box
Locking
slots
Hook
A
11
Screws
Screws
B