Noise/Vibration Information; Auxiliary Handle (See Figure A) - Bosch PSB Universal Manual Original

OBJ_BUCH-2936-001.book Page 14 Monday, December 19, 2016 2:52 PM
14 | English
Impact Drill
Max. drilling dia.
– Brickwork
– Concrete
– Steel
– Wood
Chuck clamping range
Weight according to EPTA-Procedure 01:2014
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.

Noise/Vibration Information

Sound emission values determined according to EN 60745-2-1.
Typically the A-weighted noise levels of the product are
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745-2-1:
Drilling in metal:
a
h
K
Impact drilling in concrete:
a
h
K
Screwdriving:
a
h
K
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Assembly
 Before any work on the machine itself, pull the mains
plug.
1 609 92A 2LY | (19.12.16)
PSB Universal
mm 14
mm 14
mm 12
mm 30
mm 2 – 13
kg 1.7
/II
PSB Universal
dB(A) 97
dB(A) 108
dB(A) 3
2
m/s 10.0
2
m/s 2.5
2
m/s 32
2
m/s 3.5
2
m/s <2.5
2
m/s 1.5

Auxiliary Handle (see figure A)

 Operate your machine only with the auxiliary handle
10.
 Before any work, make sure that the wing bolt 9 is firm-
ly tightened. Loss of control can cause personal injury.
Turn the wing bolt 9 counterclockwise and guide the auxiliary
handle 10 over the drill chuck onto the spindle collar of the
power tool.
You can swivel the auxiliary handle 10 in order to achieve a
safe work posture that minimises your fatigue.
Swivel the auxiliary handle 10 to the required position and
retighten the wing bolt 9 in clockwise direction.
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the depth stop
11.
Press the button for depth stop adjustment 8 and insert the
depth stop into the auxiliary handle 10.
The knurled surface of the depth stop 11 must face down-
ward.
Pull out the depth stop until the distance between the tip of
the drill bit and the tip of the depth stop corresponds with the
desired drilling depth X.
+
PSB Universal
14
14
12
30
2 – 13
1.7
/II
+
PSB Universal
97
108
3
8.0
2.0
32
2.5
<2.5
1.5
Bosch Power Tools