Product Description And Specifications - Bosch PSB Universal Manual Original

OBJ_BUCH-2936-001.book Page 13 Monday, December 19, 2016 2:52 PM
 Switch off the power tool immediately when the tool
insert jams. Be prepared for high reaction torque that
can cause kickback. The tool insert jams when:
– the power tool is subject to overload or
– it becomes wedged in the workpiece.
 When working with the machine, always hold it firmly
with both hands and provide for a secure stance. The
power tool is guided more secure with both hands.
 Secure the workpiece. A workpiece clamped with clamp-
ing devices or in a vice is held more secure than by hand.
 Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and
lead to loss of control over the power tool.
 Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should
be cut off and an appropriate plug fitted in its place by an
authorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual current
device (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Technical Data
Impact Drill
Article number
Rated power input
Output power, max.
No-load speed
Rated speed
Impact rate
Rated torque
Stall torque in accordance with EN 60745
Speed preselection
Constant electronic control
Right/left rotation
Rapid Shut-off (Kickback Control)
Fully automatic spindle locking (Auto-lock)
Spindle collar dia.
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Bosch Power Tools
Intended Use
The machine is intended for impact drilling in brick, concrete
and stone as well as for drilling in wood, metal and plastic. Ma-
chines with electronic control and right/left rotation are also
suitable for screwdriving.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Keyless chuck
2 Spindle lock button (PSB Universal)
3 "Drilling/Impact Drilling" selector switch
4 Rotational direction switch
5 Lock-on button for On/Off switch
6 On/Off switch
7 Thumbwheel for speed preselection
8 Button for depth stop adjustment*
9 Wing bolt for auxiliary handle fastening*
10 Auxiliary handle with depth stop *
11 Depth stop*
12 Handle (insulated gripping surface)
13 Auxiliary handle (insulated gripping surface)
14 Universal bit holder*
15 Screwdriver bit*
16 Hex key **
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
**Commercially available (not included in the delivery scope)
PSB Universal
3 603 A31 0..
W 701
W 530
-1
min 50 – 3000
-1
min 50 – 3000
-1
min 45000
Nm 1.65
Nm 17

–

–
–
mm 43
English | 13
+
PSB Universal
3 603 A31 1..
800
560
50 – 3100
50 – 3100
46500
1.45
19





43
1 609 92A 2LY | (19.12.16)