How To Wire Your Ceiling Fan - Emerson PRO SERIES CF712AB02 Manual Del Usuario

BP7300-7 CF712 PRO SERIES.qxp_BP7300 3/2/15 1:48 PM Page 13
The following instructions show that the Hanger Ball/Downrod Assembly and the Close-To-The-Ceiling
Assembly wiring instructions are the same.
9.1
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
Connect the green grounding lead from the hanger ball
and the green grounding lead from the hanger bracket
to the grounding conductor of supply (this may be a
bare wire or wire with green colored insulation)
(Figure 14). Securely connect wires using wire
NOTE: When wiring the ceiling fan for close-to-the-
connectors supplied.
ceiling mounting, there will be no green grounding
lead from the hanger ball.
9.2
Securely connect the fan motor white wire to the supply
white (neutral) wire using wire connector supplied
(Figure 15).

9. How to Wire Your Ceiling Fan

WARNING
!
Hanger Ball/Downrod Assembly Shown
Figure 14
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Hanger Ball/Downrod Assembly Shown
FAN MOTOR
WHITE WIRE
Figure 15
Please contact 1-800-654-3545 for further assistance
13
GROUND
CONDUCTOR
SUPPLY
LISTED WIRE
CONNECTOR
GREEN WIRE
(GROUND)
FROM
HANGER
BRACKET
GREEN WIRE
(GROUND) FROM
HANGER BALL
SUPPLY WHITE
(NEUTRAL)
LISTED WIRE
CONNECTOR
emersonfans.com
U.L. Model No.: 52-ANT