Toro 20601 Manual Del Operador página 3

2
Assembling the Hitch Tube
and Corner Tubes
Parts needed for this procedure:
2 Corner tube
1 Hitch tube
Procedure
1. Attach corner tubes to the hitch tube by pressing
down on the valco pins and locking them into place
in the valco holes (Figure 3).
1
2
3
4
5
1. Lawn mower handlebars
2. Vertical tubes
3. Valco holes
2. Attach the corner tubes to the vertical tubes by
pressing down on the valco pins and locking them
into place in the valco holes (Figure 3).
Note: When setting width and height of the
assembly, make sure the valco pins on each side are
in matching holes on the opposite side.
G015780
6
Figure 3
4. Valco pins
5. Corner tube
6. Hitch tube
3
Adjusting Angle and Height
No Parts Required
Procedure
1. Angle the assembly as close to the mower as possible
by moving the clamps up or down on the mower
handlebars without hitting the mower or impeding
the mower bagging system (Figure 4).
G015776
1. Valco hole
2. Fully tighten the 2 pan head screws and 4 phillips
screws.
3. Set the height of the assembly using the valco pins on
either side, making sure the assembly is a minimum
of 3-1/2 inches off the ground.
3
1
2
Figure 4
2. Minimum of 3-1/2 inches