Toro 20601 Manual Del Operador página 4

4
Filling and Attaching Roller
Assembly
Parts needed for this procedure:
1 Roller plug
1 Roller assembly
Procedure
1. Fill the roller assembly with approximately 16 to 20
lbs. of sand.
1
2
3
G015779
1. Roller plug
2. Pour dry sand into here
2. Seal the roller assembly with roller plug (Figure 5).
Important: Make sure the roller plug is fully
tightened. Failure to do so will result in roller
plug impeding the roller's ability to turn.
3. Attach the sand-filled roller assembly onto hitch tube
hook as shown in Figure 6.
Figure 5
3. Roller assembly
G015777
1. Hitch tube
4. Verify that the roller assembly does not interfere
with any part of the mower, including other kits or
safety features.
4
1
Figure 6
2. Roller assembly
2