Installation Procedure; Install Appliance - Gaggenau VG 414 210 CA Instrucciones De Instalación

For flush mounting:
“
“





Installation Procedure

Install Appliance

9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1 Hold the set plate against the front panel from the
rear. Insert the control knob in the hole from the
front and screw it down from the rear with the nut.
Secure the set plate against torsion with the
enclosed screw.
12


PLQ 


PD[



PP

2 Evenly insert the unit in the cut-out. Press the unit
firmly into the cut-out from above.
Note: The unit must sit firmly in the cut-out and
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.
3 Turn the control knob and the gas valve to the
zero position. Assemble the spindle between the
control knob and the gas valve. Slide the rear part
fully over the gas valve shaft. Fix the spindle in
place with the locking screw.
D
E
4 Connect the appliance to the mains and gas and
check that it is working. If the appliance switches
off, there may be air in the gas pipe. turn the
control knob to 0 and ignite again. Repeat the
operation until the appliance ignites.
5 Flush installation only : it is imperative to test
functioning before jointing!
F
Joint the surrounding