Gaggenau VG 414 210 CA Instrucciones De Instalación página 15

plastic part on the gas valve so that the recess is
above the respective nozzle. Unscrew the nozzle
and pull it out with a small pair of pliers.
Z
5 Fully screw in the new low-setting nozzles as
detailed in the table of nozzles.
6 Slide the spindles onto the gas valve and firmly
tighten the locking screws. Fit and firmly tighten
the cover plates.
Replacing the main nozzles Wok burner
1 Detach securing clips from the burner pipes.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
2 Losen the burner holder.
3 Remove nozzle and O-ring for inner circular
burner by hand. Unscrew nozzle for outer circular
burner (SW10).
Z
4 Check that O-ring is correctly positioned in new
main nozzle for inner circular burner. Push nozzle
onto burner pipe. Screw new main nozzle for
outer circular burner all the way into nozzle fitting.
5 Put on nozzle fitting and burner pipes. Put on
securing clips.
6
Z
7
8
Checking functions after the conversion:
The flames are adjusted correctly if no yellow tips are
visible. They must not go out when switching over
swiftly from the high to the low setting.
Note: Stick the adhesive label included with the
nozzle set over the rating plate of the appliance to
document the changeover to a different gas type.
Z
Set air-regulating sleeve to correct dimension
after loosening the screw (see nozzle table).
Tighten screw again.
/
Fit the cooktop and screw it down evenly. Fit
burner parts and pot supports, paying attention to
correct positioning.
Set the pressure regulator to the correct pressure
(see section "Connect Gas Supply").
15