Domo B3958 Manual Del Usuario página 82

B3958 www.domo-elektro.be
You can remove the kneading paddles, after the dough has been kneaded for the last
time.
Shortly press the 'start/stop' button to interrupt the baking process or disconnect the
plug from the power socket.
Open the lid and take out the bread pan. Take out the dough with flowered hands and
remove the kneading paddles.
Place the dough back in the bread pan and close the lid.
Insert the plug into the power socket and press the 'start/stop' button. The program
will be continued.
Do not activate the bread maker, if the appliance hasn't cooled down or warmed up
yet.
HOW TO USE THE TIME DELAY FUNCTION
When you want to use the time delay function, you should program it before you press
the 'start/stop' button.
IMPORTANT: never use the time delay function with easily perishable ingredients.
Please carry out the first 8 steps, as described in the chapter 'Operating instructions'.
Next you press the 'Time +' or the 'Time –' button in order to adjust (decrease or
increase) the time set on the display.
Cf. chapter 'display'.
Example: the time is 9 am and you want your bread to be ready by 5 pm. Put all
ingredients in the bread pan. Place the bread pan in your bread maker. Close the
lid and select the program and the crust colour of your choice, using the respective
buttons.
Keep pressing the 'Time +' button until you see '8.00' on the display. For, evidently,
8 hours will pass between the time you press the 'start/stop' button and the time you
want your bread to be ready (in this case 5 pm).
Press the 'start/stop' button. The colon on your display will start to flash and the
bread maker will start the countdown, until it is time for the bread maker to begin the
kneading. The bread maker will let the program run entirely, ensuring the bread will
be ready at the desired time.
If you want to use the 'Cake' program, you cannot program the time delay function.
HOW TO CLEAN YOUR BREAD MAKER
Before cleaning your bread maker, please make sure it's no longer activated, it has
sufficiently cooled down and the plug has been disconnected from the power socket.
Make sure the appliance doesn't get in contact with splashing water or liquids, to
82