Tripp-Lite POS Serie Manual Del Propietário página 5

Basic Operation
The second beep occurs after three seconds and indicates the UPS system will
perform a self-test if the button is released. The test will last approximately 10
seconds as the UPS switches to battery to test its load capacity and charge. All
LEDs will be lit, and the UPS alarm will sound. See LED descriptions below to
determine the results of the self-test.
Note: You can leave connected equipment on during a self-test.
CAUTION! Do not unplug your UPS system to test its batteries. This will
remove safe electrical grounding and may introduce a damaging surge into
your network connections.
2
LINE POWER: This green LED will illuminate whenever the UPS system is ON and
receiving normal AC line power.
3
BATTERY POWER: This yellow LED will illuminate when the UPS system is providing
battery power to connected equipment.
4
CHECK BATTERY: This red LED will illuminate continuously if a UPS self-test
determines the battery is weak. If it remains illuminated when a second self-test is
run after the UPS system has been allowed to charge for 12 hours, contact
Tripp Lite for service.
CAUTION! If the LED flashes and a continuous alarm sounds during a
prolonged blackout or brownout, the UPS system's batteries are nearly out
of power. You should save files and shut down your equipment immediately. If
the LED illuminates following a self-test (after the UPS is turned ON), it may
indicate the battery needs to be replaced. Allow the UPS system to recharge
continuously for 12 hours, then use the ON/OFF/TEST button to run a self-
test. If the LED remains lit, contact Tripp Lite for service. Should your UPS
system require battery replacement, visit www.tripplite.com/support/battery/
index.cfm to locate the specific replacement battery for your UPS.
5
OVERLOAD: This red LED will illuminate continuously to indicate that the UPS
system is overloaded, either when the UPS system is providing power from battery or
after a self-test. If it illuminates, immediately disconnect some equipment from the
battery backup protected outlets and run a self-test.
Note: A large overload may cause the UPS system to shut down.
CAUTION! Any overload that is not corrected by the user immediately
following a self-test may cause the UPS system to shut down and cease
supplying output power in the event of a blackout or brownout.
6
BATTERY REPLACEMENT DOOR: Under normal conditions, the original battery in
your UPS system will last several years. Battery replacement should be performed
only by qualified service personnel. Refer to the Battery Warnings section. Should
your UPS system require battery replacement, visit www.tripplite.com/products/
battery-finder/ to locate the specific replacement battery for your UPS system.
17-05-141-932716.indb 5
5
5/24/2017 3:17:37 PM