Cleaning - Panasonic ER‑SB40 Instrucciones De Funcionamiento

Ocultar thumbs Ver también para ER‑SB40:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning

• Clean the main body, blade and the attachment after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Turn the appliance off.
• Remove the main body from the AC adaptor.
With water
► Main body, blade and the attachment
To remove light dirt
1. Remove the attachment
and turn the appliance on.
2. Run water down the water
inlet at the front of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the appliance
off.
• Rinse with water and
shake up and down
several times to remove
the water.
ER-SB40_CAN.indb
13
To remove heavy dirt
1. Remove the attachment and
blade.
(See pages 11 and 14.)
2. Clean the main body, the
blade and the attachments
with running water.
• Rinse with water and
shake up and down
several times to remove
the water.
3. Wipe off the water with a
towel and let it dry naturally.
• It will dry faster with the
blade removed.
4. Apply the oil to the blade after
drying. (See page 14.)
5. Attach the blade and
attachment to the main body.
The mark on the left means suitable for cleaning under
an open water tap.
With the brush
► Main body and blade
1. Remove the blade. (See page 14.)
2. Brush off any hair trimmings from the
main body and from around the blade.
3. Brush off the hair trimmings from the
blade edge.
4. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever (b) to raise the moving
blade.
5. Apply the oil to the blade. (See page 14.)
6. Attach the blade and attachment to the main body.
13
2017/07/18
18:04:15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido