Timer Operation; Important - Daitsu APD-9CR Manual Del Usario

Timer operation

Press the TIMER ON button can set the auto-on time of
the unit. And press the TIMER OFF button can set the
auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote controller
shows TIMER ON, the last Auto-on setting time and
the signal "h" will be shown on the LCD display area.
Now it is ready to reset the Auto-on time to START the
operation.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button, the time
increases in 30 minutes increments, up to 10 hours, then
at 1 hour increments up to 24 hours.
3. After setting the TIMER ON ,there will be a onehalf
second delay before the remote controller transmits the
signal to the air conditioner. Then, after approximately
another 2 seconds, the signal "h" will disappear and
the set temperature will re-appear on the LCD display
window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote controller
shows TIMER OFF, the last Auto-off setting time and
the signal "h" will be shown on the LCD display area.
Now it is ready to reset the Auto-off time to START the
operation.
2. Push the TIMER OFF button again to set desired
Auto-off time. Each time you press the button, the time
increases in 30 minutes increments, up to 10 hours, then
at 1 hour increments up to 24 hours.
3. After setting the TIMER OFF ,there will be a onehalf
second delay before the remote controller transmits the
signal to the air conditioner. Then, after approximately
another 2 seconds, the signal "h" will disappear and
the set temperature will re-appear on the LCD display
window.
23

IMPORTANT

The effective operation time set by the remote controller for the timer function is limited
to the following settings: 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0,
7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13, 14, 15,16,17, 18, 19, 20, 21, 22, 23 and 24.
Example of Timer setting
TIMER ON
(Auto-on Operation)
The TIMER ON feature is useful when you want the
unit to turn on automatically before say when you
return home. The air conditioner will automatically start
operating at the set time.
Example:
To start the air conditioner in 6 hours.
1. Press the TIMER ON button, the last setting of starting
operation time and the signal "h" will show on the display
area.
2. Press the TIMER ON button to display "6:0h" on the
TIMER ON display of the remote controller.
3. Wait for about 3 seconds and the digital display area
will show the temperature again. Now this function is
activated.
24